the person or item whose temperature is being measured. • ALWAYS supervise your child when using the thermometer.
NEVER allow your child to use it alone.• NEVER allow children to play with this thermometer. It is not a toy. This is a sensitive electronic device and may be damaged
if not used properly under parental supervision. • DO NOT expose the thermometer to extreme temperatures, humidity, direct
sunlight or shock, and/or dust. • Keep battery out of child's reach. Swallowing a battery could be fatal. Battery should not be
charged or placed into extreme heat as they may explode. • Used batteries should be disposed of properly.
Other Battery Information: We recommend alkaline batteries for longer battery life. DO NOT mix old and new batteries.
DO NOT mix alkaline, standard (carbon zinc) or rechargeable (nickel-cadmium) batteries. Non-rechargeable batteries are not
to be recharged. Rechargeable batteries are to be removed from the unit before being charged. Rechargeable batteries are only
to be charged under adult supervision. Only batteries of the same or equivalent type as recommended are to be used. Batteries
are to be inserted with the correct polarity. The supply terminals are not to be short-circuited. Check that all contact surfaces are
clean and bright before installing batteries. DO NOT disassemble for any reason other than inserting or replacing batteries.
How to Measure Temperature 1. Turn Thermometer On and Prep ForeheadPress and release the ON/MEMORY button. Thermometer runs a brief self-check, then beeps and displays the ready screen. The unit will default to FOREHEAD
MODE. POSITION LIGHTS at front of unit come on automatically. Prep the forehead by making sure it is clear of hair and sweat. If child has recently been in a very
warm or very cold environment, wait a few minutes for their skin to adjust to room temperature before taking their temp.
The POSITION LIGHTS are LED lights and are meant to help you feel confident about how you are aiming and distancing the unit.
-AIMING: The SENSOR LENS points at the area of the forehead between the two red POSITION LIGHTS. The right spot to aim the SENSOR LENS is
2. Position Thermometerat the base of the forehead, just above the eyebrows. So, when properly positioned, the LOWER POSITION LIGHT should be between the eyebrows.
-DISTANCE: For accurate temperatures, the unit should be within 1.5 inches (4 cm) of the forehead. When the unit is 1.5 inches from the forehead,
the UPPER POSITIONING LIGHT will be directly above the LOWER POSITIONING LIGHT (vertically.) When closer or farther away, the lights move
away from each other in opposite directions.Hint: If a child is uncomfortable seeing the thermometer coming toward his face, try turning the thermometer upside-down.
The POSITIONING LIGHTS work the same when the thermometer is upside down. 3. Measure TemperatureOnce unit is positioned, press and hold the READ TRIGGER button on the rear of the thermometer for about 1 second or until the screen lights up, displays
temperature reading, and beeps (if not in mute mode.) 4. Fever Reading IndicatorThe unit gives one long beep when temp is in normal range. Thermometer gives additional beeps and the fever bar lights up when elevated temp is detected.
NOTE: High, prolonged fever requires medical attention, especially for young children. Please contact your physician. Fever chart included.
5. Wait timer &After a reading is complete, the WAIT icon will flash for 5 seconds. After those 5 seconds are complete, the unit will return to READY mode. Thermometer beeps
Auto Shut-Off and shuts off automatically after about 30 seconds in READY mode.This thermometer can also be used to take no-touch temperatures of liquids like bath water and milk/formula. Unit defaults into FOREHEAD MODE every time
6. Liquid Modeyou turn it on. To switch to LIQUID MODE, simply press the MODE button on the handle of the thermometer. NOTE: To return to FOREHEAD MODE, press MODE
button again. NOTE: Once in LIQUID MODE, positioning lights and fever bar are no longer needed. NOTE: Room temperature is between 50°F and 104°F (10°C - 40°C). Display Meaning Recommended Action • Error 3, the ambient temperature is not within range • Allow the thermometer to rest in a room for at least 15 minutes at room temperature. • Error 5-9, the system is not functioning properly • Remove batteries, wait 1 minute and repower unit. If the message reappears, contact Consumer • Forehead Mode: Temperature taken is higher than 108°F (+42.2°C) • Allow the thermometer to rest in a room for at least 15 minutes at room temperature. • Liquid Mode: Temperature taken is higher than 176°F (+80°C) • Target is too cold to read using this thermometer. If in forehead mode, try moving unit closer to • Forehead Mode: Temperature taken is lower than 89.6°F (+32°C) the forehead. • Liquid Mode: Temperature taken is lower than -7.6°F (–22°C) • Remove batteries, wait 1 minute, and repower unit. If the message reappears, contact Consumer • Device cannot be powered on to the ready stage Make sure the thermometer has been at room temperature for 30 minutes before use. Troubleshooting Display Recommended Action • Batteries are low. Replace them. (See Battery Information section).• For best accuracy, wait one minute between temperature measurements so that thermometer has time to
re-acclimate to the room's temperature.• Do not return this product to the place of purchase. If any parts are missing, email support@djgusa.